INTEGRATION

Designing the AGS-M1 into your system.

The board answers to your host over RS-485 or TTL serial, with a checksum on every frame. With the simulator and the test vectors, your side of the link can be written and tested before a board is on your bench.

THE KIT

What comes with the board.

The software is working and early. It is not sold: we send the simulator and the test vectors on request.

ICD

INTERFACE CONTROL DOCUMENT

Electrical interface, framing, commands and the register map in one numbered document, in preparation now.

VECTORS

BYTE-EXACT TEST VECTORS

Machine-generated frames, checksums and edge cases, for checking your host implementation byte for byte.

SIM

INSTRUMENT SIMULATOR

A full simulator of the board with fault injection, for testing your host against its behaviour without hardware.

HOST

OPERATOR SOFTWARE

A Windows application for live streaming, spectrum and noise analysis, and self-describing, checksum-verified recordings.

PROTOCOL AT A GLANCE

Simple on the wire, strict about integrity.

The host asks and the board answers, one frame at a time. A damaged frame costs one retry, never a hung link.

Physical
RS-485, two-wire half-duplex, 100,000 baud; or 3.3 V TTL serial, point to point, 921,600 baud. Both 8-N-1, one link per power-up, set by a switch on the board
Bus discipline
Poll and response. The host is the only master; the board never transmits unprompted
Framing
COBS-encoded, zero-byte delimited; at most 252 bytes on the wire
Integrity
CRC-32 (IEEE) on every frame; a bad frame is dropped and the link resyncs within one frame
Faults
A pending-fault flag rides on every response
Register map
Fixed since July 2026; later revisions only add entries. The full map is in the interface document, in preparation
Recordings
Downloaded with resumable, CRC-verified readback

DESIGN · as the design specifies it, not separately measured

HOW AN INTEGRATION STARTS

A conversation, not a checkout.

Every integration starts with an email to the person who designed the board: king@airandgravity.com

  1. 01

    YOUR NUMBERS

    The field range, bandwidth, noise floor and environment your design needs.

  2. 02

    THE KIT

    Sent as each part is ready, so your host side can start before a board arrives.

  3. 03

    OUR BENCH

    We measure a board against your numbers and share the raw data.

  4. 04

    YOUR BUILD

    Rev B boards for your build. They are built and on the shelf now.